nexys_board_switches
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
nexys_board_switches [2016/12/04 00:15] – added interrupt-disabling switch gurce | nexys_board_switches [2018/02/17 23:33] (current) – Switch 12 no longer used for hypervisor debug output (shift-key on usb keyboard is) gurce | ||
---|---|---|---|
Line 6: | Line 6: | ||
This switch is handy when in trace mode and you're constantly getting the pc moving away from your current code due to interrupts. | This switch is handy when in trace mode and you're constantly getting the pc moving away from your current code due to interrupts. | ||
+ | |||
+ | ===== Switch 8 - Dummy 8KB cartridge ===== | ||
+ | |||
+ | This was mentioned in one of Paul's blog posts: | ||
+ | |||
+ | https:// | ||
+ | |||
+ | > Fourth, the Nexys4DDR boards thought that they always had an 8KB cartridge plugged in if switch 8 was not set. This was a debug thing I put in when getting the cartridge interface to work some time ago, and of course then promptly forgot about, resulting in a few hours of lost time trying to figure out why on earth I was seeing 30719 BYTES FREE, but no actual data in the mapped cartridge. | ||
===== Switch 11 - Trace mode on ===== | ===== Switch 11 - Trace mode on ===== | ||
Line 13: | Line 21: | ||
===== Switch 12 - Hypervisor debug output ===== | ===== Switch 12 - Hypervisor debug output ===== | ||
+ | |||
+ | __NOTE__: (18/ | ||
This switch decides whether Hypervisor debug output will be shown (via the remote serial monitor output) or not. | This switch decides whether Hypervisor debug output will be shown (via the remote serial monitor output) or not. |
nexys_board_switches.1480835706.txt.gz · Last modified: 2016/12/04 00:15 by gurce